Step 6 Install Vmware Esx 4.0 Update2 - NEC N8800-164F User Manual

Step 6 Install VMware ESX 4.0 Update2

1. Insert the install DVD of ft control
software 3.1.2 for VMware vSphere4
Update2 to start the machine.
The ftSys logo is displayed.
IMPORTANT:
Boot CPU/IO module 0 as the primary.
The capacity of the volume where
VMware ESX4.0 Update 2 and ft control
software are installed must be 20 GB or
more.
2. At the boot: prompt, press Enter to start the installation process.
3. On the Welcome page, click Next to continue
CHECK:
It is recommended to use memory of 8 GB or more.
NOTE:
If the message below is displayed, there is no problem when the displayed BIOS version is
5.0.16.
Unable to determine the required BIOS for model 'Express5800/R320b-M4'.
Please check that it is up to date.
4. The Configure Internal Disks Mirrors page appears and displays a table that describes the
internal disks in your system.
If installing to external storage, skip the procedure below. Select [Next] and proceed to the
step 5.
The table indicating the internal disk displays a pair of system disks inserted in the slot 1 of
each PCI module. The table also displays additional disks inserted in other slots, if any.
Slots containing disks that are not initialized are marked with an error symbol (
You must initialize these disks, and, if applicable, mirror them before installing the system
software. If one or both disks in this slot are initialized, but not mirrored, that is marked
with a caution symbol ( . ).
ESX Setup 4-27
).