Installing Server - NEC N8800-164F User Manual

Observe the following precautions to use the server safely. There is a risk of a death
or serious injury. For details, see "Notes for Safe Handling" in Chapter 1.
Do not install the server in non-designated places.
Do not connect the ground wire to a gas pipe.
Observe the following precautions to use the server safely. There is a risk of a burn,
personal injury, or damage to physical assets. For details, see "Notes for Safe
Handling" in Chapter 1.
Do not carry or install a rack alone.
Do not install a rack in such a manner that its weight is imposed on a single
place.
Do not assemble or disassemble parts alone.
Do not pull a device out of the rack if the rack is unstable.
Do not leave more than one device pulled out from the rack.
Do not install excessive wiring.
Do not install NEC Express5800/ft series in such places as listed below. If you locate racks or install
the server in such places, the server may malfunction.
Place where you cannot pull out the components fully.
Place that cannot sustain the total weight of the rack and its components.
Place where you cannot use stabilizers or where you cannot perform installation without
quake-resistant engineering.
Place whose floor is uneven or inclined.
Place where temperatures change widely (near a heater, an air conditioner, or a refrigerator).
Place that is subject to intense vibration.
Place where corrosive gas (sulfur dioxide, hydrogen sulfide, nitrogen dioxide, or ozone) is
generated, or a place that is close to chemicals or exposed to chemicals.
Place whose floor is covered with non-antistatic carpet.
Place that may be subject to falling objects.
Place that is close to some equipment that generates intense magnetic field (e.g., TV set,
radio, broadcasting/communications antenna, power transmission wire, and electromagnetic
crane). (If unavoidable, contact your sales agent to request proper shield construction.)
Place where the power cords of the server must be connected to outlets that share the outlet
of another device with large power consumption.
Place that is close to some equipment that causes power noises (e.g., sparks caused by
power-on/off using a relay). If you must install the server close to such equipment, request
your sales agent for separate power cabling or noise filter installation.
WARNING
CAUTION

Installing Server 3-3