Konica Minolta BIZHUB PRO C6500E User Manual page 817

Machine administrator setting
6
Place the test chart on the original glass.
– Place the test chart face down on the original glass with green
arrow pointing at the left side as shown below, and put about 10
sheets of blank copy paper on top of the chart.
Close the ADF/original cover.
7
Touch [Start] on the screen. The machine starts the adjustment
automatically.
The message "Completed" will be displayed.
If an error code (Error 1, 2, or 10) is displayed, check that the test chart
is placed properly.
If any other error code is displayed, please contact your service
representative.
8
If you want to make readjustments, press [Readjust] to display the
popup menu to confirm whether to readjust or not.
9
Repeat the adjustment steps from 3 to 8 until the desired result is
obtained.
– Touching [Adj. data reset] will display the Reset Confirmation
popup menu. Touch [YES] to reset the adjustment value to the
factory setting, or touch [NO] to cancel.
10
Touch [Return] to restore the Quality Adjustment Menu screen.
11
If further changes are required, touch the desired key.
bizhub PRO C6500 / bizhub PRO C6500e
17
17-61