Fuji Xerox DocuPrint CM505 da User Manual page 25

1) Switch the power off.
2) Press the main power switch to the [ ]
position to switch the main power off.
3) Press the <RESET> button to the reset
position. The button will be depressed
even after the pushing force is released.
4) Press the <TEST> button lightly with a
sharp edge such as a pen tip. The
depressed <RESET> button will stick out
again. This is the end of the check
procedure.
5) Press the <RESET> button back to the depressed position.
If the circuit does not work properly, contact your local Fuji Xerox
representative.
Do not attempt to remove a paper jammed deeply inside the product,
particularly a paper wrapped around a Fusing Unit or a heat roller. Otherwise,
it may cause injuries or burns. Switch off the product promptly and contact your
local Fuji Xerox representative.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
Safety Notes
Reset Button
Test Button
1
25