Installing Activex Control Module - Beward N37210 Owner's Manual

Outdoor high-quality 2-megapixel ip camera

Table of Contents

4.1. Installing ActiveX Control Module

To view camera image trough Internet Explorer, you need to install ActiveX add-on. To do

so, follow these steps:

IMPORTANT:

The installation of ActiveX components is available to the 32 bit version of Internet Explorer only.

NOTE:

The installation is shown for Internet Explorer 9.0 and Windows 7.

Step 1: open Internet Explorer, type the IP address of your camera in the address bar.

Press [Enter] or click [Go To] button.

NOTE:

Before using the camera check that the camera and PC IP addresses are in the same subnet. In other

words the IP address of your PC should be 192.168.0.xxx.

Step 2: you will see an authorization window where you should enter your username and

password (Pic. 4.2)

IMPORTANT:

Default username is admin, default password is admin.

Step 3: after first successful authorization, Windows 7 blocks the ActiveX add-on

installation on default. You will see a system notification at the bottom of the window: "This

webpage wants to run the following add-on: "AxMediaControl ActiveX Control Module"

from "BEWARD Co., Ltd." (Pic. 4.3).

Click [Allow] button to continue the installation.

N37210 Operations User Manual

Chapter 4. Managing the IP Camera via Internet Explorer

Pic. 4.2

Table of Contents