Table of Contents
Advertisement
Re-type password: enter the password again to avoid a mistake.
Send mail from: enter the sender name (up to 64 symbols).
Send test mail to: enter the reciever name.
[Test]: click this button to send a test message to check if the parameters are correct or
not.
Available Memory Buffer: displays free and total volume of the internal camera memory
which is used for temporary video data storing.
Attached type: select a type of a file which will be send:
Snapshot: send the frames to e-mail (static image) in the JPG format.
Video: send video to e-mail in avi. format.
System log: send the camera system log to e-mail.
If the "Snapshot" type is selected then "Setting" group looks as shown in the Picture 11.9
and contains the following settings:
Send (Pre-event Image): enter the number of files (0 to 7) recorded by the camera before
an alarm event triggered which will be included to the total number of files sent to the server (Pic.
11.9).
Send (Post-event Image): enter the number of files (0 to 7) recorded by the camera after
an alarm event triggered which will be included to the total number of files sent to the server (Pic.
11.9).
IMPORTANT:
The number of the frames which are recorded to a memory card will be equal to the sum of shown frame
values before and after alarm event triggered and also a frame at the moment of alarm event triggering.
So, the total number of the frames included to the sending by alarm event is Pre-event image number +
Post-event image number + 1 frame.
Image File Name: enter a file name which will correspond to the names of all files sent to
e-mail.
N37210 Operations User Manual
Chapter 11. The [SETTING] Menu: Event
Pic. 11.9
72
Advertisement
Table of Contents
