Table of Contents
Advertisement
7.0 MAIN MENU
The main menu gives you access to Installation, Channels, System Setup, Multimedia and Network
functions. To access the main menu, press MENU in viewing mode. Throughout the main menu,
MENU can be used to get back to the previous screen and
7.1 Installation of channels
Use t u to select the main menu item Installation.
Use p q to highlight the submenu of choice and press OK to select.
7.1.1 Auto Search
This menu allows you to search for channels from all available frequencies for your selected region
automatically. Be aware that all previous installed channels and favourite list(s) will be deleted. The
new found channels will be installed in the channel list and afterwards you can create a new favourite
list if you like.
The option T2 Signal Only is to select between No DVB-T+T2 or selection Yes only DVB-T2 modulation
type. When in doubt, use the No selection.
Highlight Search and press OK to start scanning.
7.1.2 Manual Search
This menu allows you to search for channels at a specific Frequency or Channel number.
Use p q to select Scan mode and select between By Channel which allow to select standard steps or
select By Frequency to allow entering specific frequencies.
Use p q to select Channel No and select the channel number of the frequency you'd like to search.
Highlight Search and press OK to start scanning. New found channels will be added to the channel
list.
7.1.3 Country
Here you can select other region in which the receiver is used, before you will do a new auto scan
process. The selections England, Hungary, Poland, Denmark, Italy and France will store channels in
Logical Channel numbering (LCN). This means that it is operator defined which channel will be stored
on position 1 and so on. Sorting of channels afterwards is not possible. If you like to sort the channels
yourself, set the region/country to Other. Press
7.1.4 Antenna Power
If you use an active antenna (with built-in amplifier), then switch the Antenna Power to On. This will
supply at the ANT IN connector 5volt to antenna trough the coax cable. If you use a passive antenna
(without built-in amplifier), then select Off.
Number 6 Opens the option to select and deselect for deleting a record file(s).
Marks a recording for deletion. When all recordings you want to delete are
marked, press EXIT.
to quit.
to leave.
11
Advertisement
Table of Contents
