Installation - Strong SRT 8202 User Manual

Use pq to select Rename Favourite List from the Edit Channel Menu and press ok to proceed. The
names of all groups are now displayed. Select a favourite group with pq and press ok to edit its
name. A text field will now pop up at the right of the screen. Use tu pq to select characters and
enter them with ok. When you have finished editing, press bLUE to save the changes. When all
changes have been made, press EXIT twice to leave this menu.

7.2 Installation

7.2.1 Auto Scan
Use pq to select Installation and press ok or u to advance.
Select Auto Scan with pq and press ok to enter.
Use tu to toggle between Yes or No.
When FTA Only is set to Yes, scrambled channels won't be stored in the channel list.
When T2 Signal Only is set to Yes, DVB-T channels won't be stored in the channel list.
Use pq to highlight Search. Now press ok to start auto scan.
The receiver will store all found channels in the channel list.
7.2.2 Channel Scan
Use pq to select Installation, press ok or u to advance.
Use pq to select Channel Scan and press ok to enter.
Use tu to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use the cursor buttons to select Scan Band and Channel No.
If By Frequency is selected, use the cursor buttons to select Frequency and Bandwidth.
Option Network Search select Yes or No. If set to Yes the receiver will use additional information
provided by the operator to optimize the searching process.
Highlight Search and press ok to start scanning. Newly found channels will be added to the channel
list.
7.2.3 Antenna Power
Use pq to select Installation, press ok or u to advance.
Use pq to select Antenna Power and press ok to enter.
Set to On if you use an active antenna.
Select Off for passive antennas.
When set to On, 5 V will be present on the ANT IN connector of the receiver.
Press EXIT to leave the Antenna Power menu.
14