Table of Contents
Advertisement
Rev 1.2
mechanism particular to the cable vendor. When a logical connection is made the green light will
come on. When data is being transferred the light will blink green.
To remove, disengage the locks and slowly pull the connector away from the port receptacle. The
LED indicator will turn off when the cable is unseated.
Care should be taken not to impede the air exhaust flow through the ventilation holes next to the
InfiniBand ports. Cable lengths should be used which allow for routing horizontally around to the
side of the chassis before bending upward or downward in the rack.
5.3
Disassembly of the Switch from the Rack
5.3.1 Disassembly Procedure — Single Switch Centered Installation
To disassemble the switch from the rack:
1.
Unplug and remove all connectors.
2.
Unplug the power cord.
3.
Remove the ground wire.
4.
Remove the four M6 screws holding the switch to the rack. Support the switch while remov-
ing the screws, or the switch may fall out of the rack.
5.
Loosen the two thumbscrews holding the switch in place.
6.
Slide the switch out of the rack.
This switch needs to be supported when it is being disassembled.
7.
Remove the rails.
8.
Remove the caged nuts.
28
Mellanox Technologies
Cables in the bottom row should be inserted up side down in relation to the how the
cables are inserted in the top row.
Figure 14: Top and Bottom Ports
Installation
Hide quick links:
Advertisement
Table of Contents
