Installing Map Micro Sd Card - Bryton Rider 60 User Manual

NOTE:
• Align both sensor and magnet as shown in the illustration (3) and (4). Pay attention on the
alignment points.
• Ensure the distance between the sensor and the magnet is within 3 mm.
• On the initial usage, do the following:
1. Press the
2. Start pedaling.
3. When the cadence magnet comes across the sensor, the red LED blinks. When the speed
magnet comes across the sensor, the green LED blinks.
4. The LED blinks only for the first 10 passes after pressing the
5. If you want to check the alignment status after 10 passes, just press the
repeat step 1~4.

Installing Map Micro SD Card

If you purchase an additional map, please follow these instructions to install your map Micro
SD card.
1. Pull up the micro SD card cover.
2. Slide from left to right to unlock the micro SD card slot.
3. Use your fingernail to open the micro SD card slot.
4. Insert a micro SD card into the micro SD card slot.
Make sure the metal contacts are facing down.
5. Close the micro SD card slot.
6. Press and slide from right to left to lock the micro SD
card slot.
NOTE: If you want to remove a micro SD card, pull up the micro SD card cover and slide
from left to right until it pops up.
48 Rider 60 User's Manual
button. The LED blinks from red to green, indicating the sensor is working.
button.
button and