Page 2
Rider 60 The Rider 60 comes with a touch screen. You can click on the touch screen to operate the device or use the hardware button to operate the device. PAGE Power/Back/Pause/ Lap/Ok/ Record ( Stop ( / / / ) BACK •...
Rider 60 to ensure the battery will be fully charged. • You can also charge the device using a power adapter. The Rider 60 may come with different plug head(s) suitable in the country where you purchased the device.
Press and hold to turn the device on or off. Step 3: Initial Setup When turning the Rider 60 on for the first time, the setup wizard appears on screen. Follow the instructions to complete setup. 1. Select the display language.
Page 5
• Good Note: • If the “___” appears on the screen, this indicates that the Rider 60 cannot detect the sensor. When this occurs, check if the sensors are properly installed. Refer to page 8 and 9 for more details.
2. Register an Account Go to http://www.brytonsport.com and register an account. 3. Connect to PC Turn on your Rider 60 and connect it to your computer by using USB cable. 4. Share Your Experience With Other Bikers When My Device Manager window starts up, do one of the following: a.
Getting More Information Getting the User’s Manual To download User’s Manual, please go to > Support > Download. http://corp.brytonsport.com Installing the Bike Mount To mount Rider 60 onto your bike, do the following: Rider 60 Quick Start Guide...
Page 8
• Align both sensor and magnet as shown in the illustration (3) and (4). Pay attention on the alignment points. • Ensure the distan ce between the sensor and the magnet is within 3 mm. Rider 60 Quick Start Guide...
Page 9
Adjust the sensor position to the middle part of the body (wear it slightly below the chest). The Bryton logo shown on the sensor should be facing upward. Tighten the elastic belt firmly so that it will not turn loose during the exercise.
RF Receiver 2457MHz ANT+ receiver with embedded antenna for ANT+ sport protocol Bluetooth Bluetooth wireless technology Barometer 300 ~ 1100 hPA (+9000 ~ -500 m above the sea level) Buzzer Battery type Rechargeable Lithium Battery Rider 60 Quick Start Guide...
1 hour per day for 1.4 years Operating temperature ~ 60 °C °C Radio frequency/protocol 2.4GHz ANT+ wireless communication protocol Note: Accuracy may be degraded by poor sensor contact, electrical interference, and receiver distance from transmitter. Rider 60 Quick Start Guide...