Troubleshooting; Getting More Information; Reset Rider 60; Sensor Pairing Issues - Bryton Rider 60 User Manual

Hide thumbs Also See for Rider 60:

Quick start manual (13 pages)

Manual (62 pages)

Table Of Contents

Table of Contents

Getting More Information

Go to

http://corp.brytonsport.com

Reset Rider 60

Press and hold the three buttons (p/LAP/q) at the same time until the device restarts.

Sensor Pairing Issues

Heart rate sensor

If no heart rate sensor is detected or the heart rate sensor is inactive, check the following:

1. Please warm up the heart rate monitor for about 5 minutes.

2. While pairing your speed/cadence sensor, please make sure there is no other speed/

cadence sensor with 5m.

3. In cold weather, wear appropriate clothing to keep the heart rate belt warm.

4. Adjust the sensor position to the middle part of the body. The belt should be worn

under the chest and directly on your body. The Bryton logo shown on the sensor should

be facing upward. Tighten the elastic belt firmly so that it will not turn loose during the

exercise.

5. Check your battery status or change a new battery.

Speed/Cadence sensor

If no speed/cadence sensor is detected or the sensor is inactive, check the following:

1. Make sure the speed/cadence sensor is properly installed. Ensure the distance between

the sensor and the magnet is within 3 mm. Refer to

Sensor

at page 47 for detailed instructions.

2. Make sure you have pedaled the wheel to active the sensor so that the data can be

transferred onto your Rider 60.

3. Wheel size not set correctly. You can set your wheel size in Settings (

Bike 1/Bike 2 > Bike profile > Wheel. Refer to

for more information.

4. Sensor priority issue: By default, your speed source would always come from priority 1

(GPS). It would only switch to priority 2 (Speed Sensor) if GPS signal is lost. Similarity, it

would switch to the next priority if the previous one is not available. If you would like to

do indoor training, please set speed source from Speed Sensor or Dual Sensor based on

the one you would like to record your speed. Refer to

page 26 for more information.

5. Check your battery status or change a new battery.

44 Rider 60 User's Manual