Table of Contents
Advertisement
Firmware Updates
Figure 8.
The Target Card ID field should remain at 0. WinLoad will put the firmware on the right card.
7.4.2
Communications Settings
To set the communications port and baud rate, select COM Settings from the Settings menu, see Figure 9 on
Page 107. Choose the port on your PC from the Com Port drop down list and the baud rate from the Download
Baudrate drop down list. The baud rate should be as high as possible (the default of 115200 is preferred).
7.4.3
Downloading Firmware
To download firmware follow these steps:
1. Set up the communications port as described in Section 7.4.2, Communications Settings above.
2. Select the file to download, see Open a File to Download on Page 106.
3. Make sure the file path and file name are displayed in main display area, see Figure 8.
4. Click on the Write Flash button to download the firmware:
5. While WinLoad searches for the card, power cycle the receiver (turn it off and then on again).
You will only be able to access information from the card and download new firmware during the first few
seconds after power initiation.
6. WinLoad should be able to locate the card and the hex file should start downloading. When the
EuroPak-15ab Receiver User Manual Rev 1
Figure 8: Open File in WinLoad
Table 50: Target Card Identification
Entry
Description
0
Euro-L1E5a card or Euro-E5ab card
Figure 9: COM Port Setup
Chapter 7
107
Advertisement
Table of Contents
