Commands; Functional Listing Of Commands; Commands By Function - Novatel EuroPak-15ab User Manual

Chapter 5
5.1

Functional Listing of Commands

Table 13 lists the commands by function. Please see Section 5.3 on Page 48 for a more detailed description of
each individual command.
Command
ANTENNAPOWER
COM
LOG
UNLOG
UNLOGALL
AGCMODE
RESET
FRESET
FIX
POSITIONTYPE
ASSIGN
CHANCONFIG
ECUTOFF
PULSEBLANKING
SDLLBW
SPLLBW
STHRESHOLD
EXTERNALCLOCK
46

Commands

Table 13: Commands By Function
COMMUNICATIONS, CONTROL AND STATUS
Control power to low-noise amplifier (LNA) of an active antenna
Set serial port configuration
Request a log
Remove a specified log from logging control
Remove all logs from logging control
GENERAL RECEIVER CONTROL
Control Automatic Gain Control (AGC) functionality
Perform a hardware reset
Reset receiver to factory default
POSITION CONTROL
Constrain receiver position
Control the position solution on GPS L1 or L5 signals
SATELLITE TRACKING AND CHANNEL CONTROL
Assign individual satellite channel
Set receiver channel tracking configuration
Set satellite elevation cut-off angle
Enable/disable digital pulse blanking for L1 Galileo or E5a/E5b signals
Configure channel's DLL filter bandwidth
Configure channel's phase-lock-loop bandwidths
Control signal channel thresholds for acquisition, tracking and cross correlation
CLOCK INFORMATION, STATUS, AND TIME
Set the parameters for an external clock
Description
EuroPak-15ab Receiver User Manual Rev 1