Table of Contents
Advertisement
Chapter 4
String
OK
NOT ENOUGH RESOURCES IN
SYSTEM
DATA PACKET DOESN'T VERIFY
COMMAND FAILED ON RECEIVER
INVALID MESSAGE ID
INVALID MESSAGE FIELD = X
MESSAGE MISSING FIELD
ARRAY SIZE FOR FIELD X EXCEEDS
MAX
PARAMETER X IS OUT OF RANGE
TRIGGER X NOT VALID FOR THIS LOG
NO VALID AUTH CODE FOR THAT
MODEL
CHANNEL IS INVALID
REQUESTED RATE IS INVALID
CHANNELS LOCKED DUE TO ERROR
INJECTED TIME INVALID
COM PORT NOT SUPPORTED
MESSAGE IS INCORRECT
INVALID PRN
MESSAGE TIMED OUT
UNKNOWN COM PORT REQUESTED
HEX STRING NOT FORMATTED
CORRECTLY
INVALID BAUD RATE
MESSAGE IS INVALID FOR THIS
MODEL
COMMAND ONLY VALID IF IN NVM
FAIL MODE
INVALID OFFSET
MAX NUMBER OF USER MESSAGES
REACHED
GPS PRECISE TIME IS ALREADY
KNOWN
36
Table 4: Response Messages
ID
1
Command was received correctly
The request has exceeded a limit (for example, the
3
maximum number of logs are being generated)
4
Data packet is not verified
5
Command did not succeed in accomplishing requested task
6
The input message ID is not valid
7
Field x of the input message is not correct
9
A field is missing from the input message
10
Field x contains more array elements than allowed
11
Field x of the input message is outside the acceptable limits
14
Input trigger x is not valid for this type of log
19
The model attached to the authcode is not valid
20
The channel number is not correct
21
The requested rate is invalid
23
Channels are locked due to error
24
Injected time is invalid
25
The COM port is not supported
26
The message is invalid
27
The PRN is invalid
31
The message has timed out
33
Unknown COM port requested
34
Hex string not formatted correctly
35
The baud rate is invalid
36
This message is invalid for this model of receiver
40
Command is only valid if NVM is in fail mode
41
The offset is invalid
The maximum number of user messages allowed has been
78
reached
84
GPS precise time is already known
EuroPak-15ab Receiver User Manual Rev 1
Using Commands and Logs
Meaning
Advertisement
Table of Contents
