Assign Assign Individual Satellite Channels - Novatel EuroPak-15ab User Manual

Commands
5.3.3

ASSIGN Assign Individual Satellite Channels

The ASSIGN command should only be used by advanced users.
This command may be used to aid in the initial acquisition of a satellite by allowing you to override the
automatic satellite/channel assignment and reacquisition processes with manual instructions. The command
specifies that the selected tracking channel should search for a specified satellite at a specified Doppler
frequency within a specified Doppler window.
The instruction remains in effect for the specified SV channel and PRN, even if the assigned satellite
subsequently sets. If the satellite Doppler offset of the assigned SV channel exceeds that specified by the
window parameter of the ASSIGN command, the satellite may never be acquired or re-acquired. If a PRN has
been assigned to a channel and the channel is currently tracking that satellite, when the channel is set to AUTO
tracking, the channel will immediately idle and return to automatic mode.
To cancel the effects of ASSIGN, you must issue the following:
• The ASSIGN command with the state set to AUTO
This returns SV channel control to the automatic search engine immediately.
1. Assigning a PRN to an SV channel does not remove the PRN from the search space of the
automatic searcher; only the SV channel is removed (i.e. the searcher may search and lock onto
this PRN on another channel). The automatic searcher only searches for PRNs 1 to 32 for GPS
channels and 1 to 32 for Galileo channels.
2. Assigning an SV channel will set the Channel Assignment bit to 1 for forced assignment in the
Channel Tracking Status field of the RANGE log. The RANGE log is specified in Section 6.3.5 on
Page 84.
EuroPak-15ab Receiver User Manual Rev 1
Chapter 5
51