Understanding Exception Trigger Options - HIKVISION DS-7200-ST Series User Manual

User Manual of DS-7200-ST Series DVR
Figure 20. Exception Menu
4.
Click OK to save settings and exit Exception menu.
Note:
The Trigger Alarm Output option is not available for DS-7200HVI-ST/SE, DS-7200HFI-ST/SE,
DS-7200HVI-ST/SN and DS-7200HFI-ST/SN models as they provide no alarm in/out.

Understanding Exception Trigger Options

When setting up exception handlers for such features as motion detection and relay alarms, you may select
triggering options to alert you of these exceptions.
alarm shop
The triggering options that you may select include:
•
Pop-up Image on Monitor: When an alarm is triggered, the local monitor (VGA or BNC monitor)
will display an image in Live View mode. This alarm can be configured under the Popup Alarm
Image handle method. For alarms that are triggered simultaneously, images will be displayed one at a
time every 10 seconds (default dwell time). A different dwell time can be set by going to Menu >
Settings > Display > Dwell Time. Once the alarm stops, cycling of the images will also stop and
you'll be returned to the Live View screen.
•
Audio Warning: Trigger an audible beep when exception is detected.
•
Notify Surveillance Centre: Sends a signal to remote alarm host when exception is detected (See
Configuring Remote Alarm Host Settings).
•
Trigger Alarm Output: Trigger an alarm output when exception is detected. Alarm output can be
configured by following the steps listed in Sensor Alarm Settings.
Note:
The Trigger Alarm Output option is not available for DS-7200HVI-ST/SE, DS-7200HFI-ST/SE,
DS-7200HVI-ST/SN and DS-7200HFI-ST/SN models as they provide no alarm in/out.
78