Using A Usb Mouse; Using The Soft Keyboard - HIKVISION DS-7200-ST Series User Manual

User Manual of DS-7200-ST Series DVR
indicator does not turn green and there is still no response from the remote, please check the following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
4. No fluorescent lamp is used nearby.

Using a USB Mouse

A regular 3-button (Left/Right/Scroll-wheel) USB mouse can also be used with this DVR. To use a USB mouse:
1. Plug USB mouse into one of the USB ports on the front panel of the DVR.
2. The mouse should automatically be detected. If in a rare case that the mouse is not detected, please
refer to the recommended device list from your provider.
The buttons on the mouse corresponds to:
1. Left Button:
•
Single-Click: Select a component of a menu, such as a button or an input field. This is similar to
pressing the ENTER button on the remote/front panel controls.
•
Double-Click: Switch between single screen and multi-screen mode in Live View/ Playback
mode.
•
Click and Drag: Clicking and dragging the Left mouse button can be used to control the pan/tilt
of a PTZ camera as well as to vary the position of digital zoom area and camera OSD. It can also
be used to setup the alarm areas.
2. Right Button:
•
Single-Click: Shows pop-up menu.
3. Scroll-Wheel:
•
alarm shop
Scroll Up: In Live View mode, scrolling up will switch to the previous screen. In Menu mode, it
will move the selection to the previous item.
•
Scroll Down: In Live View mode, scrolling down will switch to the next screen. In Menu mode,
it will move the selection to the next item.

Using the Soft Keyboard

When a mouse is used to perform task on the DVR, clicking on a text input field will bring up the Soft Keypad,
shown in Figure 17.
Figure 17. Soft Keypad
The buttons on the soft keyboard represents:
Lowercase: Designates lowercase input is being used.
Uppercase: Designates uppercase input is being used.
Switch to Lowercase: Switch to lowercase input.
Switch to Uppercase: Switch to uppercase input.
Number: Designates number input is being used.
21