Problems With Express Setup - NEC Express5800/53La User Manual

8-20 Troubleshooting

Problems with Express Setup

Specified to join the Domain, but the system is installed as Workgroup.
When the setup fails to join the Domain during the installation, it will install the
→
system as Workgroup. Open [System] in Control Panel to specify joining the
Domain.
There is unused area on the lead of HDD:
Did you install Windows XP?
If you had installed Windows XP by Express Setup, the head 8MB of HDD may
→
be unused area.
It is not a problem in operating the system.
During auto installation, the system started from another partition, or failed to start from it.
When you select "Use existing partitions" and yet another active partition exists,
→
this problem may occur.
Inactivate the active partition that is not used to install.
The contents of the external hard disk drive was erased during the Express Setup.
Did you connect the other hard disk drives except the drive that you want to install
OS?
Disconnect the other hard disk drives except the drive that you want to install OS,
→
before you start the Express Setup.
Express Setup terminated and asks to input setup information.
There are some errors on the specified setup information.
→
Follow the instruction to input the correct value.
It is not necessary to cancel the installation.
Can not select applications.
Did you connect the board that corresponds to the application?
Did you connect the board besides the RAID controller(LSI Embedded
MegaRAID is included) to install OS?
Express Setup does not support the environment that several RAID controller (LSI
→
Embedded MegaRAID is included) exist together.
Please disconnect the RAID controller(In case of LSI Embedded MegaRAID,
disable it) to which OS will not be installed before you start the Express Setup.