NEC Express5800/53La User Manual page 116

4-44 Configuring Your Workstation
Setting of Priority
LSI Software RAID Configuration Utility displays and sets Rebuild Priority and Consistency Check
Priority of RAID Controller by percentage. However, Universal RAID Utility uses three levels as
High/Middle/Low for them.
See the table below for correspondence.
Setting value of LSI Software RAID Configuration Utility
Item
Rebuild Priority
Rebuild Rate (LSI Software
RAID Configuration Utility)
Consistency Check Priority
Chk Const Rate (LSI Software
RAID Configuration Utility)
Setting level of Universal RAID Utility and the setting value
Item
Rebuild Priority
Rebuild Rate (LSI Software
RAID Configuration Utility)
Consistency Check Priority
Chk Const Rate (LSI Software
RAID Configuration Utility)
NOTES:
With LSI Software RAID Configuration Utility, you can set FGI
Rate (Foreground Initialize Priority) and BGI Rate (Background
Initialize Priority). However, you cannot set the Background
Initialize Priority with Universal RAID Utility.
Setting Initialization Priority is available in Universal RAID Utility.
However, the Initialization Priority to the LSI Embedded
MegaRAID cannot be set. Accordingly, the [Initialization
Priority] does not appear in [Options] tab of property of RAID
Viewer.
and the display level of Universal RAID Utility
Setting value of LSI Software
RAID Configuration Utility
15 to 100
8 to 14
0 to 7
15 to 100
8 to 14
0 to 7
Setting level of Universal
RAID Utility
High
Middle
Low
High
Middle
Low
Universal RAID Utility Level
High
Middle
Low
High
Middle
Low
Setting value
20
10
5
20
10
5