Table of Contents
Advertisement
(4) [RA]: Sets parameter for Read Ahead.
Parameter
Off
On *
*
Recommended setting.
(5) [Span]: Sets Span.
Parameter
SPAN=NO *
SPAN=YES
*
Recommended setting.
When performing SPAN, create two or more sets of the same pack at pack creation, as
shown in the figure below.
8.
When all settings are completed, select [Accept] and then press Enter.
The created virtual drive is displayed in the [Virtual Drive Configured] screen.
9.
Press Esc on [Virtual Drive Configured] screen to close it.
Select [Yes] on [Save Configuration?] screen to save the configuration.
10.
When the confirmation message shows that the configuration has been saved, press Esc
to return to the TOP menu screen.
11.
On the TOP menu screen, select [Objects] → [Virtual Drive] → [View/Update
Parameters] to check virtual drive information.
12.
Press Esc to go back to TOP menu.
Select [Initialize] on the TOP menu screen.
13.
When the [Virtual Drives] screen appears, move the cursor to the virtual drive to be
initialized, and press Space.
The virtual drive is selected.
Remarks
Does not perform read ahead.
Performs read ahead.
Remarks
Does not set span.
Sets span.
SPANNING of RAID1
Configuring Your Workstation 4-35
Advertisement
Table of Contents
Troubleshooting
