NEC Express5800/53La User Manual page 297

6.
The following message is displayed.
If you use the floppy disk drive, insert the Windows XP OEM-Disk for
EXPRESSBUILDER into the floppy disk drive, and press Enter.
NOTE:
A list of mass storage devices is displayed.
IMPORTANT: If you have created the OEM-Disk into the Flash FDD,
connect the Flash FDD before you start the system.
7.
Select the proper Controller and press Enter.
– [LSI Embedded MegaRAID (Windows XP/2003 32-bit)]
(When Onboard RAID Controller (LSI Embedded MegaRAID) is used.)
The screen of Step 5 is displayed.
Press Enter, and go to Step 8.
8.
Continue performing tasks according to the subsequent messages that appear.
For details, refer to "Getting Started".
9.
Install the "Step By Step Interactive (SBSI)" if necessary.
SBSI, a training software to learn Windows XP, provides a simple and easy-to-use training
environment with talking animation. SBSI is installed as follows;
(1) Insert the SBSI CD-ROM into the optical disk drive.
(2) Run the \setup.exe in the optical disk drive.
Follow the messages on the screen hereafter and continue the setup.
After installation is completed, be sure to execute the tasks described in "Driver Installation and
Advanced Settings" and "Updating the System" of this manual.
Please insert the disk labeled
manufacturer-supplied hardware support disk
into Drive A:
*Press ENTER when ready.
If you use the Flash FDD, the message above is not displayed.
Installing Windows XP E-9