Installation - NEC N8100-1644F User Manual

9-54 Upgrading Your Server

Installation

Take the following steps to install a PCI card on the riser card:
IMPORTANT:
Each riser card supports low-profile or full-height PCI cards. Before
installing a PCI card, confirm that the type of the PCI card.
When installing a PCI card, confirm that the card connector matches
the connector of the riser card.
1.
See page 197 to prepare.
2.
Pull out the server from the rack (as described on page 197).
3.
Remove the logic cover (as described on page 214).
4.
Hold the riser card handle and bracket as shown in the figure below, and remove the riser
card.
If the card is hard to remove, hold down the server while lifting the card.
NOTE:
5.
Check the insertion positions in the table on the previous page.
6.
Remove the screw from the PCI slot cover at the insertion position.
1C
Be very careful not to contact the other component.
2C
3C
Low-profile riser card
3B
2B
Full-height side riser card