NEC N8100-1644F User Manual page 320

8-58 Troubleshooting
IMPORTANT:
Do not change the boot device order in BOOT menu in BIOS
SETUP. NEC EXPRESSBUILDER cannot be used if the
DVD-ROM drive is not the first device to launch the system.
Connect the LAN cable to the connector on management LAN port.
Or, connect the LAN cable to LAN connector 1 if Shared BMC
LAN feature is used.
Use the serial port B for direct connection.
To use this feature, you need to create a configuration file (3.5-inch
floppy disk) that includes communication method between the
server and the management PC, and various setup parameters. Use
NEC ESMPRO Manager or run "System Management" menu from
NEC EXPRESSBUILDER to create a configuration file. Save the
configuration file into the root directory of the floppy disk as the
following file name.
– File name: CSL_LESS.cfg
If you exit the BIOS SETUP by unusual way (e.g., forced power-off
or reset), the redirection process may fail. In such a case, setup
again by using the configuration file.
On Windows Server 2008, you need to open Device Manager,
disable the COM port, and restart the system to use the direct
connection through COM port.
NOTE:
shown below.
LAN Controller:
Serial Port A:
Base I/O Address:
Interrupt:
Serial Port B:
Base I/O Address:
Interrupt:
BIOS Redirection Port:
Baud Rate:
Flow Control:
Console Type:
The following items of BIOS setup information will be set as
[Enabled]
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Serial Port B]
[19.2K]
[CTS/RTS]
[PC ANSI]