Table of Contents
Advertisement
[Advanced] menu of the BIOS setup utility, make sure that the [PCI
Slot xx ROM] parameter (where xx is the PCI slot number) under [PCI
Configuration] is set to [Enabled].
IMPORTANT:
hibernation or standby mode.
1.
See page 197 to prepare.
2.
Pull out the server from the rack (as described on page 197).
3.
Remove the logic cover (as described on page 214).
4.
Hold the riser card handle and bracket as shown in the figure on the right, and remove the
riser card.
If the card is hard to remove, hold down the server while lifting the card.
IMPORTANT:
any other components.
5.
Remove the bracket from the server.
When N8103-129/130 is inserted, do not switch to the
Carefully remove the riser card so as not to contact
Screws
Upgrading Your Server 9-59
Advertisement
Table of Contents
Troubleshooting
