Create The Example Application - Allen-Bradley ControlLogix User Manual

7-2 PLC-5C to Logix5550 Controller: Unscheduled Messaging

Create the Example Application

1756-6.5.3 - December 1999
Verify that the node address for the 1756-CNB module is 1 and the node
address for the PLC-5C is 11 as shown.
Verify that the KTCX15 driver card is configured as described on
page 2-3.
Verify that all wiring and cabling is properly connected.
Perform the following steps to create the example application:
1. Start the RSLogix5 software.
2. From the File menu, select New. The Select Processor Type window will
appear.
3. Enter the following information and click on OK.
In this field
Processor Name
Platform
Processor
Series
Revision
Driver
Processor Node
(1)
F Series is recommended but not required.
Ignore any prompts or warnings you receive about specifying
ControlNet project files. That is not necessary for unscheduled
messaging used in this example.
Select
SENDER
ControlNet
(Enter your processor type)
(1)
(Enter your series)
(Enter revision letter)
AB_KTC-1
11