Create The Logix5550 Producer Application - Allen-Bradley ControlLogix User Manual

6-2 Logix5550 Controller to PLC-5C: Scheduled Communications
Create the Logix5550 Producer
Application
The producer application here is the
same as that in chapter 4. If you
previously created that application,
open it in RSLogix5000 and download
it to the producer Logix5550
controller. Then proceed to Schedule
the Network Using RSNetWorx for
ControlNet on page 6-7.
1756-6.5.3 - December 1999
Verify that the Logix5550 controller and the 1756-CNB module are in
slots 0 and 1 as shown.
Verify that the node address for the 1756-CNB module is 1 and the node
address for the PLC-5C processor is 11 as shown.
Verify that the KTCX15 driver card is configured as described on
page 2-3.
Verify that all wiring and cabling is properly connected.
Perform the following steps to create the Logix5550 producer application.
1. Open the RSLogix5000 software.
2. From the File menu, select New. The New Controller window will
appear.
3. Enter an appropriate name for the Controller, e.g., "Producer."
4. Select the correct Chassis Type, Slot Number of the Logix5550
controller, and folder where you want to save the file (Create In). Click
on OK.