Set Up The Example Application; Create The Example Application; Existing Controlnet Network Set Up The Example Application - Allen-Bradley ControlLogix User Manual

11-2 Adding an I/O Chassis to an Existing ControlNet Network

Set Up the Example Application

Create the Example Application

1756-6.5.3 - December 1999
Change the system configuration of the previous chapter to that shown
below by adding the second remote chassis with a 1756-CNB module and a
1756-OF6VI analog output module:
Slot 0 1
Local
Chassis
Logix5550
1756-CNB
Controller
(Node 1)
ControlNet
Network
Verify that the Logix5550 controller, I/O modules, and 1756-CNB
modules are in the correct slots as shown above.
Verify that the node addresses for the 1756-CNB modules are 1, 6, and 3
as shown.
Verify that the KTCX15 driver card is configured as described on
page 2-3.
Verify that all wiring and cabling is properly connected.
Perform the following steps to create the example application:
1. Open the RSLogix5000 software.
2. From the File menu, open the program created for the example
application in chapter 10 (i.e., "Remote_IO").
3. Save the program as Remote_IO_2.
1756-CNB
(Node 6)
Slot 0 1
PC with
1784-KTCX15
Interface
Slot 1 2 3
Remote
Chassis
#1
1756-OB16I
Digital Output
1756-IB16
Digital Input
Remote
Chassis
#2
1756-OF6VI
Analog Output
1756-CNB
(Node 3)