2-10
Installing the ControlNet Network
Required Software
1756-6.5.3 - December 1999
The following figure shows an example of a completed ControlNet network
used for the examples in chapters 5 and 6 of this manual.
ControlLogix
Chassis
Logix5550
Controller
tap with end
terminator
In order to run the example applications, you will need RSNetworx for
ControlNet, RSLogix5, and RSLogix5000 software installed on your
personal computer. Refer to the System Components table on page P-3 for
information on which versions of the software are required. Follow the
instructions that appear on your screen when installing the software.
For further information, refer to the publications listed on page P-5.
1756-CNB
ControlNet Trunk Cable
tap
PC with
1784-KTCX15
Interface
PLC-5C
1771 I/O
Chassis
tap with end
terminator