Removing The Access Panel And Chassis Stiffener - HP ProLiant DL145 User Manual

Removing the Access Panel and Chassis Stiffener

1. Power down the server. Refer to the "Powering Down the Server" section earlier in this
chapter.
2. Extend the server from the rack. Refer to the "Extending the Server from the Rack"
section earlier in this chapter.
3. Remove the access panel.
Figure 2-3: Removing the access panel
4. Remove the chassis stiffener, if necessary.
HP ProLiant DL145 Server User Guide
WARNING: Pressing the Power button does not remove power from all areas of the
server. Portions of the power supply and some internal circuitry remain active until the
AC power cord is disconnected.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching.
CAUTION: Electrostatic discharge can damage electronic components. Properly ground
yourself before beginning any installation procedure.
Server Operations
2-3