HP ProLiant DL145 User Manual page 99

Table F-5: Server Cannot Load Operating System
Problem
Server cannot load
operating system.
HP ProLiant DL145 Server User Guide
Possible Cause
Required operating
system step was
missed.
Primary hard drive
controller installation is
incorrect.
Hard drives and other
devices may not be set
to proper boot order in
Boot Device Priority
settings in BIOS Setup.
New hardware was
added to the system.
Hardware was added to
a system with a
factory-installed
operating system.
Possible Solution
Follow these steps:
1. Note at which phase the operating system
failed.
2. Remove any loaded operating system
components.
3. Refer to the operating system
documentation.
4. Reinitiate installation procedures.
Run BIOS Setup by pressing the F10 key and
correct this problem.
Run BIOS Setup by pressing the F10 key and
correct this problem.
Refer to the documentation provided with the
hardware.
Remove the new hardware.
The factory-installed operating system software
installation must be completed before adding
new hardware to the system.
Be sure that all instructions provided in the HP
Factory-Installed Operating System Software
Installation Guide are being followed.
Remove the new hardware and complete the
software installation. Then, reinstall the new
hardware.
Troubleshooting
F-5