Using Cli Commands - HP ProLiant DL145 User Manual

Operating System Installation and Software

Using CLI Commands

CLI commands are entered at the ProLiant> prompt that appears after a successful login to
the Management Processor. For more information on logging in to the Management
Processor, refer to "Logging In to the Management Processor CLI" in this chapter.
Table 5-8 lists and describes the CLI commands. The commands are described in further
detail in the sections that follow.
IMPORTANT: CLI commands are case-sensitive.
Table 5-8: Basic CLI Commands
Command
changepassword
power on
power off
ipmicommand command
command
command
sdrread
selread
network setup*
reset warm
reset cold
help
quit
* Entering
changing from ProLiant> to INET>. For information on additional
commands that can be entered at the INET> prompt, refer to "Setting Up
the Network" in this chapter.
5-20
, where
is a supported IPMI
network setup to configure the network results in the prompt
Description
Change the password.
Power on the server remotely.
Power off the server remotely.
Execute an IPMI command.
Display the sensor data records.
Display the System Event Log.
Set up the network.
Reset the server.
Power off the server and reset the
server after a short time has passed.
Display a list of commands.
Log out of the Management
Processor .
HP ProLiant DL145 Server User Guide