J9 Cmos Jumper - HP ProLiant DL145 User Manual

J9 CMOS Jumper

Figure 1-5: J9 CMOS Jumper
Table 1-5: J9 CMOS Jumper Settings
Item
1
2
To clear CMOS:
1. Back up the server data.
2. Shut down the operating system as directed by the operating system documentation.
3. Press the Power button to power down the server. When the server powers down, the
system power LED turns off.
4. Disconnect the power cord.
5. Set the J9 CMOS jumper to Clear and hold in position for 3 seconds.
6. Reset the J9 CMOS jumper to Set.
7. Connect the power cord.
8. Power up the system.
9. Reconfigure the server using the BIOS Setup Utility. Refer to Chapter 5, "Operating
System Installation and Software" for more information on the BIOS Setup Utility.
HP ProLiant DL145 Server User Guide
Setting
Set
Clear
Server Component Identification
1-5