Remove The Chassis Access Panel - HP Apollo 2000 Maintenance And Service Manual

If an HP Smart Storage Battery is installed, slightly pull up the battery holder from the chassis to access
10.
the battery cable connection underneath it, and then disconnect the HP Smart Storage Battery cable.
Remove the PDB cover (on page 31).
11.
Remove the screw.
a.
Slide back the PDB cover and remove it from the chassis.
b.

Remove the chassis access panel

Power down the system (on page 27).
1.
Disconnect all peripheral cables from the nodes and chassis.
2.
Remove all nodes from the chassis
3.
If installed, remove the security bezel (on page 31).
4.
Remove all drives
5.
("Remove the node from the
("Hot-plug drive" on page 58).
chassis" on page 27).
Removal and replacement procedures 32