HP ProLiant DL145 User Manual page 77

Operating System Installation and Software
Setting Up the Network
Administrator and OEM level users can configure the network settings for the Management
Processor. To configure the settings:
1. Log in to the Management Processor CLI as described in "Logging In to the Management
Processor CLI" in this chapter.
2. At the ProLiant> prompt, enter
3. Enter any Management Processor network setup command. The available commands are
described in Table 5-9.
IMPORTANT: CLI commands are case-sensitive.
Table 5-9: Network Setup Commands
Command
state
delay
host
length
rtadd
rtdel
routes
setip
xxx.xxx.xxx.xxx
yyy.yyy.yyy.yyy
where
xxx.xxx.xxx.xxx
the IP address and
yyy.yyy.yyy.yyy
is the subnet mask
setdgw
dhcp
firewall
setfirewall
quit
help
help general
help diagnostics
help telnet
5-22
network setup
Description
Display the current setup information.
Set the milliseconds to wait between pings.
Set the default active IP host.
Set the default ping packet length.
Manually add an IP route to the table.
Manually delete an IP route from the table.
Display the IP route table.
Set the Management Processor IP address and
subnet mask.
,
is
Set the Management Processor default gateway.
Enable or Disable DHCP.
Display the current firewall settings.
Set the firewall parameters.
Quit network setup.
Display menu help.
Display menu help.
Display diagnostic commands.
Display Telnet commands.
. The INET> prompt appears.
HP ProLiant DL145 Server User Guide