Gas Connection - Falcon 1000 DF User's Manual & Installation And Servicing Instructions

Screw down the roller until it touches the bottom and
then make 10 complete (360°) turns clockwise.
Make sure you lower all three rollers. Unfold the rear
edge of pack base tray. Carefully push the cooker
backwards off the base pack and remove the pack base.
Push the cooker close to its fi nal position, leaving just
enough space to get behind it.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section of
these instructions.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust
the height of the rear of the cooker use the levelling tool
supplied to turn the adjusting nuts at the front bottom
corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfi ed with the height and level raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the fl oor.
Screw the front roller adjuster anticlockwise to raise the
front roller so that the front of the cooker is supported
on the feet, not the front roller, to prevent accidental
movement of the cooker.

Gas Connection

Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fi tted when the cooker is connected
to a fl exible gas supply. Any restraining device should be
secured to the fabric of the building and should be able
to be released so that the cooker can be pulled out for
cleaning and maintenance.
When fi tting a stability bracket read these instructions
together with the leafl et supplied with the bracket.
17
English