Setting Drive Scsi Ids; Setting The Date And Time - ADIC Scalar 100 User Manual
Intelligent storage
Hide thumbs
Also See for Scalar 100:
- User manual (346 pages) ,
- Quick start manual (2 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
Setting Drive SCSI IDs
Use Drive to set drive SCSI IDs. The drive SCSI IDs must be different from other SCSI devices on the SCSI
bus. Available SCSI IDs are 0 to 15.
Path: Main menu > More > Setup > Drive > SCSI
To set a drive SCSI ID
1
From the Main menu, select More. Select Setup and then select Drive. Select SCSI.
2
Use Change Drive to select the drive whose SCSI ID you want to set.
3
Select Next.
4
Use Up and Down to pick the new SCSI ID for that drive.
The CURRENT column displays the current SCSI ID. The NEW column displays the new SCSI ID.
5
Select Next.
6
After the dialog is refreshed, the Drives with this ID shows how many other drives use the selected
SCSI ID. If it displays NONE, select OK. Otherwise, change the drive SCSI ID so that it is unique.
The library resets the SCSI IDs of the affected drives.
7
When complete, select OK.
Setting the Date and Time
Use Date/Time to set the library date and time used by the library logs and displayed on the Operator Panel.
Note that this does not affect the date and time used by the Remote Management Unit (RMU), but does
affect the date and time shown in the logs retrieved by the RMU.
Path: Main menu > More > Setup > Utils > Date/Time
76
Configuring your Library
Advertisement
Table of Contents
