Preparing The Host - ADIC Scalar 100 User Manual
Intelligent storage
Hide thumbs
Also See for Scalar 100:
- User manual (346 pages) ,
- Quick start manual (2 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
4
Install the cables between the bottom drive and the Library Controller and between the Library
Controller and the host.
If you have more than one SCSI bus, connect a cable between the bottom drive on the SCSI bus to the
host.
Preparing the Host
If necessary, install a SCSI host system adapter, software, and compatible driver(s). Refer to the manuals
for the host system and SCSI host system adapter for detailed instructions. In addition, follow these general
guidelines:
•
When the host server system is turned on, install the software, and/or driver(s) that are compatible
with the library.
•
If the host server system is connected to a network, check with the system administrator before
turning off the power to the host.
•
Prevent electrostatic discharge (ESD) by following proper procedures. Always use wrist-grounding
straps and anti-static mats when handling internal components.
•
Make certain the host server system has an open expansion slot.
26
Setting up your Scalar 100
Advertisement
Table of Contents
