Setting The Scsi Ids - ADIC Scalar Series Installation And Operating Manual

Setting the SCSI IDs

Your Scalar Library consists of up to five SCSI devices; four drives and the library robotics. The library can be
connected to from one to five separate SCSI buses. Each device in your library must be set to a unique ID for the
SCSI bus it is connected to. The ID for the robotics is set by selecting it through the Operator Panel, Off-Line
Mode, Configuration Menu, Set SCSI ID option (see sub-subsection Set SCSI ID, subsection Configuration Menu,
section Off-Line Mode Menus in Chapter 4: Equipment Description of this manual). The IDs for the drives are set
by selecting the appropriate ID on the rotary switch on the back of each drive assembly.
Drive
SCSI ID
Rotary
Switches
Drive
SCSI I/O
Connectors
Library
SCSI I/O
Connectors
Drive SCSI ID Rotary Switches
11
Getting Started