Adjusting The Lamination Placement On The Card - Fargo DTC4500 User Manual

© 2010 HID Global Corporation

Adjusting the Lamination Placement on the Card

The Card Lamination Module provides an adjustable Lamination Placement knob that allows you to fine-
tune where the lamination is being placed on the card.
Step Procedure
• The Lamination Placement Adjustment Knob is the light gray knob to the
1
right of the Lamination Cartridges.
• The printer will have one or two film cartridges loaded (depending on
whether this is a Single or Dual-Side Lamination Module).
2 Print a test card to see if the Lamination placement needs to be adjusted.
Turn the knob to the right to move the patch toward the front edge of the
Lamination Module. Turn the knob to the left to move the patch toward the
back edge of the lamination module.
DTC4500 Card Printer/Encoder User Guide
All rights reserved
L001444 Rev1.0
87