Fargo DTC4500 User Manual page 50

© 2010 HID Global Corporation
Selecting the Advanced Settings tab
Setting
Flipper Lam Height
Offset
Mag HI-Co Voltage Offset
Mag Lo-Co Voltage
Offset
OLED Contrast
(display contrast)
Resin Heat Adjust
Head Resistance
DTC4500 Card Printer/Encoder User Guide
Option
This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated, this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
This option changes the voltage going the magnetic head.
(Note: This is factory set and should not be changed
unless directed by a technician.)
This option changes the voltage going the magnetic head.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Use this option to increase or decrease the contrast of the
printer OLED (if applicable).
Use this adjustment for Black resin text and barcodes Iif
they appear faded or too light/dark.
•
Maximum Adjustment Range is +/- 100.
(Note: This control can be helpful for fine-tuning the
transfer of resin text and bar codes.)
This is factory set. If the main board or the Printhead is
replaced then adjust this number.
Locate the Printhead Setting Number on the bottom of the
Printhead.
The number reads R=XXXX.
All rights reserved
L001444 Rev1.0
50