Fargo DTC4500 User Manual page 109

© 2010 HID Global Corporation
Troubleshooting with the Error Message Table
Error Message
# 53
Lam Card Jam
# 52
Lam Generic Error
# 48
Check Lam Power
Lam Heater Off
#59
Lam Heater Timeout
DTC4500 Card Printer/Encoder User Guide
Cause
A jam occurred somewhere
between the Printer and the
Laminator
Laminator firmware error
Lam is connected but not
powered.
See the next column.
See the next column.
Solution
Open covers and clear the
obstruction/jam
Cycle power and try again.
If this problem persists call for
technical assistance.
Power off the Printer, power the
Laminator, and then power on
the Printer.
A damaged Flipper board, E-
Card board, or EEPROM could
potentially result in this same
error.
If this problem persists, call for
technical assistance.
If this problem persists, call for
technical assistance.
All rights reserved
L001444 Rev1.0
109