Fargo DTC4500 User Manual page 108

© 2010 HID Global Corporation
Troubleshooting with the Error Message Table
Error Message
# 144
EEPROM Corrupt
EEPROM Read
Error
# 170
Ribbon Calibration
failed
#202
Encoder not
installed
No UV Protection
DTC4500 Card Printer/Encoder User Guide
Cause
EEPROM restored with factory
default values.
Ribbon calibration failed.
You are trying to send
encoding data, but the Printer
is not configured with this
Encoder type.
iCLASS,Prox,Mifare,SmartCard
Ribbon type selected does not
contain an overlay or
overlaminate
Solution
• If changes were made in the
Advanced Setting Tab in the
Printer Driver, click the
Default button to reset these
numbers.
• Reset the Printer and try
again. If this problem
persists, call for technical
assistance.
Check for material blocking
sensor and try again.
• Ensure that no encoding
data is being sent with the
print job and reprint the card.
• Install an Encoding Module.
The current printer driver setup
does not have any protective
coating being applied to the
front or back of the card. Select
YES to continue or NO to alter
the settings.
All rights reserved
L001444 Rev1.0
108