Sending The Track Information - Fargo DTC4500 User Manual

© 2010 HID Global Corporation

Sending the Track Information

Magnetic track data is sent in the form of text strings from the application software to the Printer Driver.
•
In order for the Printer Driver to differentiate between Magnetic Track data and the rest of the printable
objects, specific characters must be added to the magnetic data to be encoded.
•
These specify the data that is to be encoded, the tracks to encode and mark the start and stop of the
data string. In some cases, these specific characters are automatically added to the string of track data
by ID software applications.
•
In most cases, the user must carefully add these characters to the string of Magnetic Track data. If
these characters are not added to the track data, the text intended for the Magnetic Track will appear
as printed text on the card. To avoid this, track information must be entered as described below.
Step Procedure
1 When entering track data, the ~ (tilde) character is entered first, followed by the
track number (1, 2 or 3) on which the data should encode. This is followed by
the data to be encoded.
•
The first character of this data string must be the track's specific Start
Sentinel (SS) and the last character must be the specific End Sentinel
(ES).
•
The characters or data in between the SS and ES can include all of the
valid characters specific to each track.
•
The number of these characters, however, is limited by each track's
maximum character capacity.
•
When segmenting track data, the appropriate Field Separator (FS) must be
used. The table below shows the SS, ES, FS and the valid characters
defined for each track.
DTC4500 Card Printer/Encoder User Guide
All rights reserved
L001444 Rev1.0
69