Normal Operation - Takagi Mobius Water Heater T-M32 ASME Installation Manual And Owner's Manual

NORMAL OPERATION

• Flow rate to activate the T-M32: 0.5 gallon per minute
• Flow rate to keep the T-M32 running : 0.4 gallon per minute
1. Open a hot water tap.
WITH REMOTE CONTROLLER INSTALLED: TM-RE30 (Optional)
*If the TM-RE10 is used, refer to the TM-RE10 Installation Manual included with the remote.
1. Press the power ON/OFF button.
Temperatures available under the Default Mode
100 105 110 115
Temperatures available under the High Temperature Mode
110 115 120 125
DO NOT set to 185 °F if you use your T-M32 in recirculation system. Refer to p.34
3. Open a hot water tap.
Mix cold water with the hot if you need.
Hot Water temperatures over 125°F can cause severe burns
instantly or death from scalding.
• The outlet hot water temperature of the Mobius T-M32 water
heater is factory set at 120°F.
• Feel the water temperature before bathing or showering.
1. NORMAL OPERATION
WITHOUT REMOTE CONTROLLER
2. Mix cold water with the hot to get
the correct temperature water.
2. NORMAL OPERATION
When ON,
green LED is lit.
The temperature and the
time will be displayed on
the remote controller.
120 125 130 135
130 135 140 145
Lamp is ON
Lamp is ON
WARNING
2. Set temperature. (Example 110°F)
140 145 150 155
150 155 160 165
4. Close the hot water tap.
- 31 -
3. Close the hot water tap.
160 165 170
170 175 180
(unit:°F)
Lamp is OFF
Lamp is OFF
NING
175
185