Table of Contents
Advertisement
• Flow rate to activate the water heater
• Flow rate to keep the water heater running
1.
Open a hot water tap.
NOTE: The water temperature is set at 50 °C from the factory.
If you desire to change the set temperature without remote controller, refer to diagram below.
5
6
7
ON
40 °C
OFF
5
6
7
ON
60 °C
OFF
• Only change the switches with dark squares.
• DO NOT adjust other switches.
WITH ONLY MAIN REMOTE CONTROLLER INSTALLED
1. Press the ON/OFF button. And then ensure the priority lamp is
lit and displays the set temperature on the remote controller.
2. SET PREFERRED TEMPERATURE. WHEN ADJUSTING THE SET
TEMPERATURE,
TEMPERATURE FROM THE WATER HEATER TO BE ADJUSTED
WITHIN THE RANGE OF 37 °C to 55 °C. (Please refer to P. 14.)
3. Open a hot water tap, and ensure the BURNER ON lamp is lit.
Mix cold water with the hot if you need.
4. Close the hot water tap, and ensure the BURNER ON lamp is
OFF.
NORMAL OPERATION
WITHOUT REMOTE CONTROLLER
2.
Mix cold water with the hot to get
the suitable temperature water.
8
ON
45 °C
OFF
8
ON
Error
OFF
MC100-AU3-TP
ALLOWS THE OUTPUT
Temperature set
5
6
7
8
50 °C
DEFAULT
5
6
7
8
70 °C
18
: 3.0 LITRES per minute
: 2.5 LITRES per minute
3.
Close the hot water tap.
5
6
7
8
ON
55 °C
OFF
5
6
7
8
ON
Error
OFF
Priority
lamp
Priority
Burner on
button
lamp
MC100-AU3-TP
5
6
7
8
ON
OFF
5
6
7
8
ON
OFF
Set temperature
display
ON/OFF
button
Set temperature
adjust button
Hide quick links:
Advertisement
Table of Contents
