Normal Operation; Without Remote Controller - Takagi GS-20W-AU5 Installation Manual And Owners Manual

13. NORMAL OPERATION

• Water temperatures above 50 °C can cause severe burns or death from scalding.
Children, the disabled and the elderly are at a high risk of being injured. Feel the
water temperature before bathing or showering. Do not leave children, disabled
persons, or the elderly unsupervised. The Australian Standards AS 3498 gives full
details of the requirements for supply of controlled temperature to ablution out-
lets (bathrooms) and is required to be conformed to under all plumbing codes
within Australia.
• For continued safety of this appliance, it must be installed and maintained in accord-
ance with the manufacturer's instructions.
• Flow rate to activate the water heater
Notice
• Flow rate to keep the water heater running : 1.8 LITRES per minute

WITHOUT REMOTE CONTROLLER

1.
Open a cold water tap.
NOTE: The water temperature is set at 50/60 °C from the factory*. If you want to change the set
temperature of hot water without remote controller, refer to diagram below.
• Turn off the power supply to the water heater before changing the DIP switch set-
tings.
• Only change the switches with dark squares.
• DO NOT adjust other switches.
• DO NOT mistake on-direction for off-direction of the switch.
40°C
OFF
ON
8 7 6
55°C
OFF
ON
8 7 6
2.
Mix hot water with the cold
water to get the suitable temper-
ature water.
Temperature settings
45°C
OFF
ON
8 7 6
60°C
OFF
60°C
MODEL
ON
DEFAULT
8 7 6
WARNING
WARNING
50°C
50°C
MODEL
DEFAULT
8 7 6
18
: 2.3 LITRES per minute
3.
Close the water taps.
*NOTE:
50 °C models: GS-20W-AU5
OFF
60 °C models: GS-20W-AU6
ON
The set temperature of
55/60 °C is not available for
50 °C models.
GS-26W-AU5
GS-26W-AU6