Takagi Mobius Water Heater T-M32 ASME Installation Manual And Owner's Manual page 26

CAUTION
• If you connect the
"
connector of the "MASTER" unit
"
to the MASTER (or [1])
"
connector of the "SLAVE-1" unit,
the system will not work as the
easy link system. The units will
work as individual units.
Wrong connection
"
between the MASTER
"
unit and the SLAVE-1
unit
• If the TM-RE30 or the TM-RE10 remote controller (optional) is used, it has to be connected
to the "MASTER" unit. If the TM-RE30 or the TM-RE10 is connected to a "SLAVE" unit, it
will only control that particular individual "SLAVE" unit and will not control the Easy Link
system as a whole.
Wrong connection
"
between the SLAVE
unit and the TM-RE30
(or TM-RE10)
• The TM-RE30 or the TM-RE10 (optional remote controller) is not required
for the Easy Link system.
• If running the Easy Link system without the TM-RE30 or the TM-RE10,
please make sure the dipswitch settings for the temperature, outdoor, and
direct vent settings on ALL the units are set to the same settings.
Otherwise, the units may not operate properly.
• If the TM-RE30 or the TM-RE10 is used, the temperature on all the units in
the system will automatically be set to the same temperature that is set on
the remote. However, even with the remote, the outdoor and direct vent
dipswitch settings still need to be set to the same settings on all the units.
"
[1] (or [2])
"
"
MASTER unit
Left bank of
"
Dipswitches
Communication cable
MASTER unit
Connectors
Left bank of
Dipswitches
Communication cable
MASTER unit
Connectors
Left bank of
Dipswitches
Communication cable
Connectors
Left bank of
Dipswitches
- 26 -
SLAVE-1 unit
Connectors
Left bank of
Dipswitches
SLAVE-1 unit
Connectors
Left bank of
Dipswitches
SLAVE unit
Connectors
T M - R E 3 0
T M - R E 1 0
o r