Temperature Settings - Takagi Mobius Water Heater T-M32 ASME Installation Manual And Owner's Manual

• There are 8 preset temperatures that you can select from by changing the dipswitch settings
on the computer board.
• The temperature has been preset at the factory to 120ºF (49ºC).
• If you desire to change the set temperature with dipswitches, please refer to the diagram on
below. These temperatures are available: 100ºF, 115ºF, 120ºF, 135ºF, 145ºF, 155ºF, 165ºF,
and 185ºF.
• If you desire a hot water temperature other than the 8 preset settings, please purchase the
optional temperature remote controller (part No. TM-RE30).
• With this optional TM-RE30 you can set the temperature from 100ºF to 185ºF with various
increments.
• Please read the instructions carefully prior to installing the TM-RE30, as failure to do so
could damage the temperature controller and/or the water heater, which will void the
warranty.
• Turn off the power supply to the heater before changing the dipswitch
settings.
• Only change the switches with the dark squares. The dark squares indicate
which direction the dipswitch should be set to.
• DO NOT set to 185 ºF if you use your T-M32 in a recirculation system. This
will cause damage to the heater and void the warranty.
7-Seg LED
Left bank of
dipswitches
Right bank of
dipswitches

Temperature Settings

Temperature Settings
100 F 115 F
100 ºF
115 ºF
(38 ºC)
(46 ºC)
(38 C) (46 C)
D-PRT D-PRT
TEMPERATURE SETTINGS
<Left bank of dipswitches>
120 F
135 F
120 ºF
135 ºF
(49 ºC)
(49 C)
(57 ºC)
(57 C)
Default
Default
D-PRT D-PRT
- 34 -
To change dipswitch settings for
temperatures, locate the left
bank of dipswitches the lower of
7-Seg LED.
DO NOT adjust the right bank of
dipswitches.
The dark squares indicate the direction
the dipswitches should be set to.
Left bank of Dipswitch
145 F 155 F
155 ºF
145 ºF
(68 ºC)
(63 ºC)
(63 C) (68 C)
D-PRT D-PRT
165 F 185 F
165 ºF 185 ºF
(74 ºC) (85 ºC)
(74 C) (85 C)
D-PRT
D-PRT