Multi-Unit System - Takagi Mobius Water Heater T-M32 ASME Installation Manual And Owner's Manual

In a Multi-Unit system, connect the
communication cable.
[3]
Wire (Male Adapter) and
(Female Adapter)
Please refer to the TM-MC01 manual for further instructions of the Multi-Unit system.
7-Seg LED
Left bank of
dipswitches
Right bank of
dipswitches
Connecting T-M32's and the T-M1's together in a
When the T-M32 and T-M1 are connected
together in a multi-unit system to the TM-
MC01, change dipswitch No. 6 on the TM-
MC01 computer board to the "ON" position.
When the T-M32 is connected to the T-M1 as part of the Multi-unit system with the TM-RE10 or
the TM-RE30, you can set the temperature from 99ºF to 167ºF/182ºF as shown below.
Temperatures available under the Default Mode
99 100 102 104
Temperatures available under the High Temperature Mode
99 100 102 104
NOTE: *The maximum set temperature with the TM-RE10
When the red jumper on the back of the TM-RE10 is installed, the maximum set temperature is 167°F. If you remove
the jumper, the maximum set temperature will be 182°F.
When the set temperature is 182°F, "H" is displayed on the TM-RE10.
*Refer to p.31 about the TM-RE30.
"
[3] connector
[4]

Multi-Unit System

106 108 110 111
106 108 110 111
- 29 -
" "
and the
T-M32 Comunication Cables are included
with the T-M32. The Cables use 18 gage
wire and can be up to 250 ft. long.
Multi-unit connectors are
on each unit's computer
board.
Do not touch the Easy Link
connectors.
The dark squares indicate the direction
the dipswitches should be set to.
O N
Dip switch setting on
113 115 117 122
113 122 131 140
"
[4] connector with the
1 2 3 4 5 6 7 8
the TM-MC01
131 140 158 167
149 158 167 182*